Three-digit Mast Signal Light (yellow, green, red), Miniland.UA 30003, H0

Three-digit Mast Signal Light (yellow, green, red), Miniland.UA 30003, H0

Made to order, production time from 7 calendar days.

The model is painted and prepared for installation on the layout.

The set includes: a signal light, instructions, a set of resistors, and a diode.

Signal Light Assembly Instructions:

Connection: Our signal lights use low-voltage LEDs designed for a DC voltage range of 5 to 16V and an AC voltage of 16V. The kit includes a set of resistors and a diode.

For connection to control circuits, use the recommended resistors:

• DC voltage 5V - x kΩ
• DC voltage 12-16V - y kΩ
• AC voltage 16V - Q kΩ, be sure to install the diode provided in the kit.

Installation recommendations: Carefully remove the signal light. Thoroughly check the functionality of the signal light with a multimeter. To install the signal light, make a hole in the sublayout with a diameter of 2.5 mm, thread the wires through the hole, and secure the signal light in a way that is convenient for you. Perform electrical connections according to the diagram on the back and the recommendations below.

Attention! Failure to follow these recommendations may result in damage to the signal light. Solder the diode with the white stripe to the black wire (in the direction of the signal light). Solder the resistors to the remaining wires. If necessary, adjust the brightness of the signal light by replacing the included resistor with another one, choosing within the range of 3 to 30 kΩ. The diode and resistor are included in the kit.

Information about the placement of colors in the signal light and the polarity of the common wire is shown in the instructions included with the signal light.